[The Page Banner feature is not available in this web]
[The link bar feature is not available in this web]
|
Tractor/Hitch Products |
ATV Products |
Farm/Tractor Accessories |
||
|
Drawbar Stabilizer
Attaches to your existing drawbar to keep it upright while towing trailers. Outer holes on 20” centers. We have sold literally hundreds of these and have yet to hear a single complaint. $45.00 |
Heavy Duty ATV Trailer
Don't be fooled by it's small size, this trailer has a 950lb rubber torsion axle under it and has been stacked twice as high as the top rail with 8' logs. For a "more scientific" test, we had a 250lb man drive his 550lb ATV onto the top of this trailer. The front and rear gates can be removed to haul longer items. This trailer can be customized for an additional cost. $799.00 |
Lynch Pin Keepers
Attaches to your tractors lift arms to keep track of those pesky lynch pins so you'll have them when you need them, where you need them. (Requires drilling two small holes in lift arm or other flat surface.) $15.00
|
||
|
Compact Drawbar Stabilizer
A smaller version of above, for compact or Cat 0 drawbars. Outer holes on 12” centers. Keeps drawbar ball upright while towing trailers. $45.00 |
|
One of the most reliable tractor resources I have found!
|
|
3/8" Drawbar Chain Hook
Another very popular item. Attaches to your drawbar to allow a quick connection for chains etc. so you don't have to rap them around the drawbar to take up slack. These are also very popular for people with front end loaders and skid steers who want to add hooks to their buckets but don't have a welder. Each hook comes with a matching backer plate to prevent bending and tearing of thin bucket steel. $17.00 |
|
Drawbar 2" Receiver with Toplink
Turn your standard drawbar/toolbar into a 2" receiver for your trailer hitches! This is a 2" Receiver that mounts to most category 0,1, or 2 factory or store bought drawbars that have holes on 2" centers. Can build to suit yours if it is non-standard or compact....email with measurements $65.00
|
||||
|
2-point 2" Receiver
2 inch receiver for most Cat 1 hitches. Allows the use of hitches from your truck to move trailers around. NOTE: This is a 2 point version and does not fit all tractors (compacts and Kubota). It will fit Ford 2000, 3000, and similar configurations. $75.00
|
2" Receiver with Toplink & Gooseneck
Same as above but with the added Gooseneck ball. $85.00
|
Trailer Jack Saver
If you have used a trailer much then I'll bet you have probably bent your trailer jack once or twice. I know I have more time than I care to mention. The biggest culprit is uneven ground. Whether you're crossing a small ditch or riding on a dirt road that has ruts, your trailer jack is bound to make contact with the ground. This handy device will minimize or even prevent the jack from bending. $25.00
|
||
|
Drawbar 2" Receiver
2 inch receiver for most drawbars. Allows the use of hitches from your truck to move trailers around. This receiver requires the use of a stabilizer. (Mounting holes are 4" apart center to center) $25.00
|
|
|
||
|
3-point HD 2" Receiver
This 3-point receiver is the Granddaddy of them all. Made using heavier duty steel, this receiver will pull just about anything. Allows the use of hitches from your truck to move trailers around. $99.00
|
|
|
||
